2 Heavy Concerns about ECE-R 64 with TPMS –The ECE R64 is about temporary use spare wheels / tires. It is not made to specify TPMS. –There are two. R Temporary use spare unit, run flat tyres, run flat system and tyre http:// ECE R Supplement 2 Temporary use spare wheels/tyres, run flat tyres, run flat system and tyre pressure monitoring system.
|Published (Last):||11 November 2015|
|PDF File Size:||7.51 Mb|
|ePub File Size:||12.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Supplement 1 to the 00 series of amendments Date g64 Entry into Force: Additional information about the significance of the low tyre pressure warning tell-tale illuminating and a description of the corrective action to be undertaken if this happens.
With the vehicle stationary and the ignition start switch in the “Lock” or “Off” position, turn the ignition start switch to the “On” “Run” position or, where applicable, r4 appropriate key position. Low Tyre Pressure Detection Phase 2.
This is done by pressing d64 key on the dashboard or via the vehicle’s operation element HMIsuch as a touchscreen. A retrofit installation into a vehicle is not yet possible. The Administrative Department issuing the extension of approval shall assign a series number to each communication form drawn up for such an extension.
The tell-tale must illuminate and remain illuminated as long as the ignition locking system is in the 6r4 “Run” position. By the end of it was used in more than If no owner’s manual is supplied with the vehicle, the information required in Paragraph 6.
For more information about run-flat tyres please ecw www. Some customers wish to have the tyre pressure value indicated on the dashboard or that tyre pressure monitoring is effected by the system even when the vehicle is stationary, neither of which comfort features is fulfilled by an indirect system.
If the system is blocked by external influence e. Second-generation Warnair ecw be applied in vehicles of the categories M1 and N1 passenger cars and light commercial vehicles. Deflate one of the vehicle’s tyres within 5min of measuring the warm pressure as described in Paragraph 2. If efe vehicle conforms to a vehicle type approved, under one or more Regulations annexed to the Agreement, in the country which granted approval under this Regulation, the symbol prescribed in Paragraph 4.
The test shall be carried out with the temporary-use spare unit fitted alternately in place of one front wheel and one rear wheel.
If the warning signal as required in Paragraph 2.
Frequently asked questions about DUNLOP TECH Warnair
With the vehicle in the normal use condition, simulate a Run-Flat Warning System failure. The whole speed range shall be covered during the test. Warnair of the latest generation can do so by means of a spectral r46 of the tyre properties. The Administrative Department which has granted type approval, may at any time verify the conformity of production in each production facility.
The Administrative Department shall verify the existence of satisfactory arrangements for ensuring effective control of the conformity of production before type approval is granted.
ECE regulations: ECE R Supplement 1
Drive the vehicle along any portion of the test course not necessarily continuously. Any tyre pressure monitoring system fitted on a vehicle shall comply with the requirements of Regulation No. Drive the vehicle along any portion of the test course. Test Weight The vehicle may be tested at any condition of load, the distribution of the mass among the axles being that stated by the vehicle manufacturer without exceeding any of the maximum permissible mass for each axle.
This value will be used for subsequent operations. Once the tyre has been changed, the correct air pressure must be set as well as Warnair put into the learning phase. Require a further test report from the Technical Service responsible for conducting the tests.
They are consolidated, published in English, and updated on a regular basis.
For vehicles equipped with cruise control, the cruise control shall not be engaged during testing. Confirmation or refusal of rce, specifying the alterations, shall be notified by the procedure specified in Paragraph 4.
The warning indication shall be by means of an optical warning signal conforming to Regulation No. If the tell-tale does not extinguish, discontinue the test.
If applicable, name and address of the Manufacturer’s representative: NET Our online subscription service, offering immediate access to our extensive library of global vehicle regulations, standards and legislation.
It shall be accompanied, in triplicate, by a description of the vehicle type with regard to the items specified in Annex 1 to this Regulation: The tests shall be conducted in an environment free of interferences from radio wave.
The test shall be performed when there is no wind liable to affect the results.