FENNER TAPER LOCK PDF

Fenner Taper Lock® bushes are machined in cast iron and steel and are available in a full range of both metric and Imperial bores and keyways. They ha. You can find the largest assortment Taper Lock bushes metric bore at ERIKS. Choose from FENNER Taper Lock® bush metric bore size · Taper Lock® . Fenner Taper-Lock Weld-on Hubs are easy to install and are entirely suitable for use. where severe operating conditions are met. Tightening the screws.

Author: Mikam Nikozragore
Country: Russian Federation
Language: English (Spanish)
Genre: Video
Published (Last): 16 January 2009
Pages: 69
PDF File Size: 12.9 Mb
ePub File Size: 18.81 Mb
ISBN: 247-8-59442-598-1
Downloads: 61731
Price: Free* [*Free Regsitration Required]
Uploader: Nanris

Email this to a friend or colleague! Then place the screws loosely into the holes that are threaded on the hub-side, as shown in Figure 1 below.

Check the bushing to ensure all surfaces are free from nicks and burrs, and ensure the bushing has no signs of cracking or fatigue. Clean the shaft, the bore, the outside of the bushing, and the bore of the hub in which the bush is to be installed into, ensuring the bush is gaper from the hub, should it already be installed.

This site will not function without Javascript! To sign in with your new password, Click here.

This will lokc cracking fenneg the bush. The Taper fenndr bush is manufactured from precision cast iron, and is machined to a high quality finish. The Taper Lock bush, also referred to as a Taper bush or Taper Fit bush, is a locking mechanism commonly used in Power Transmission Drives for locating pulleys, sprockets, and couplings to shafts.

  CISCO SPA504G MANUAL PDF

Please enter your e-mail address and we will send you a confirmation mail to reset your password. I saw this product on industrybuying. The outside of the bush is tapered to match the component bore that is to be located on the shaft.

Sign In with your Industrybuying Account. To view the demonstration video showing installation and removal of a Taper Lock bush, please Click Below. How to Fit a Taper Lock Bush.

Oil threads, the point of the set screws or threads, and under the head of the cap screws. Lightly tap against the busing to ensure it is seated squarely. The Martin and Fenner Taper Lock bushes featuring the fourth hole frnner them a preferred option in higher speed applications where balancing of the drive is critical.

Fenner Taper Lock Bush Pulleys (TLB Size 4545)

You browser has Javascript turned off! Taper bushes are available in both imperial and metric shaft sizes, ranging from 0. Please note that there should always be one screw left over that is not used when removing the bushing. Continue Browsing Continue to login. We will get back to you shortly! Thanks for contacting industrybuying! We have sent you an email enclosing confirmation link, on your ID.

  HAIRAT KADAH PDF

This information is available from the installation sheet that accompanies any new Taper Lock bush. In sizes where washers are found under the screw head, be sure to use these washers.

Thank You for your valuable feedback. See example chart below figure 3or ask for this information at any CBC office.

Repeat this alternate hammering and screw tightening until the specified torque is achieved and no longer requires tightening following hammering. Many other manufacturers generally manufacture Taper Lock bushes with an odd number of holes.

Taper Lock Bushes – Fenner Shaft Fixings

Pack of 1 pieces. Place the bushing into the hub and match half holes to make complete holes. Warranty As per Fenner’s policy. Installation of a Taper Lock Bush. Using a hammer and block, or sleeve, against the large end of the Loock Lock bush will help to avoid damage to the bushing.